CW5.1 烧写程序 出错

herohxb

      MCU clock speed: 4000000 Hz
Block Module Name      Address Range   Status
   0  PFLASH            4000 -  7FFF   Programmed - Unselected
   1  PFLASH            C000 -  FFFF   Programmed - Unselected
   2  PFLASH          E08000 -E7BFFF   Programmed - Unselected
   3  PFLASH          F88000 -FFBFFF   Programmed - Unselected
   4  DFLASH             800 -1F0BFF   Programmed - Unselected

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the DFLASH flash module => Skipped.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.

FP: Operation failed on PFLASH flash module.


FP: Operation failed on PFLASH flash module.


FP: Operation failed on PFLASH flash module.


FP: Operation failed on PFLASH flash module.


FP: Operation failed on DFLASH flash module.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: Arm FLASH for loading.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: FLASH disarmed.
executing .\cmd\TBDML_reset.cmd

!// After reset the commands written below will be executed
done .\cmd\TBDML_reset.cmd

Reset command file correctly executed.
executing .\cmd\TBDML_postload.cmd

!// After load the commands written below will be executed
RESET
done .\cmd\TBDML_postload.cmd

Postload command file correctly executed.
Error: Loading failed!

in>










已经困扰我好久了，我尝试过解锁，能解锁；但每次解完，就显示"unable to connect to target CPU"，求大神指点！！！！！！！！！